Schneider Electric Altivar 58 VW3-A58101 Manual de usuario descargar pdf (Pagina 85)

VVDED397047US R8/01 ALTIVAR



58 Keypad Display

08/01 Chapter 3 — Diagnostics and Troubleshooting

CHAPTER 3—DIAGNOSTICS AND TROUBLESHOOTING

KEYPAD DISPLAY AND INDICATING LEDS

When a fault condition is detected, a fault code and a plain language

message will be displayed as long as power is maintained. See Table 25

on page 91 for fault codes and messages. In addition, the LEDs on the

front of the drive controller indicate several states:

Figure 24: Location and Description of LEDs

FAULT STORAGE

The first fault detected is saved and displayed on the keypad display if

power is maintained. The drive controller trips, the red fault LED

illuminates, and the fault relay de-energizes. To reset the fault:

1. Remove power from the drive controller.

2. Before restoring power, identify and correct the cause of the fault.

3. Restore power. This will reset the fault if it has been corrected.

In certain cases, if automatic restart has been enabled, the drive

controller can be automatically restarted after the cause of the fault has

disappeared. See page 75.

FAULT

POWER

Other LEDs, display the state with option card installed

Green POWER LED illuminated: drive controller powered

Red FAULT LED

• illuminated: drive controller in fault

state

• flashing: drive controller in fault state

after pressing the keypad display

STOP key in terminal mode with a

Forward, Reverse, or DC injection

input active, or following a change to

the configuration. The motor cannot

be started until the Forward, Reverse,

or DC injection inputs are reset.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 111 112

Sin comentarios

Schneider Electric Altivar 58 VW3-A58101 Manual de usuario Pagina 85