Schneider Electric Altivar 58 VW3-A58101 Manual de usuario descargar pdf (Pagina 16)

ALTIVAR



58 Keypad Display VVDED397047US R8/01

Chapter 1 — Overview 08/01

If the Freewheel Stop / Run Permissive function is assigned to a

logic input, the drive controller will not start the motor unless that

logic input is connected to +24 V.

Minimum Start-Up

This procedure can be used as a minimum start-up:

• In simple applications where the drive controller factory settings are

sufficient

• In installation when it is necessary to turn the motor before fully

completing the start-up sequence

Procedure:

1. Make sure that the 50/60 Hz switch is in the correct position,

corresponding to the frequency of the incoming AC power, as shown

on page 13.

2. Ensure that the macro-configuration factory setting is suitable for

the application. Refer to Table 3 on page 22. If not, change the

configuration MACRO-CONFIG menu as shown on page 21.

3. Verify that the control scheme is compatible with the macro-

configuration, ensuring that the necessary safety precautions have

been taken.

4. Verify in the 3—DRIVE menu that the factory settings are compatible

with the motor nameplate values. Refer to Table 11 on page 39.

Modify them to match the nameplate values.

5. If necessary, adjust the parameters in the 2—ADJUST menu

(ramps, motor thermal protection, etc.). See Table 6 on page 28.

If the Freewheel Stop/Run Permissive function is assigned to a logic

input, the drive controller will not start that motor unless the logic

input is connected to +24 V.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 111 112

Sin comentarios

Schneider Electric Altivar 58 VW3-A58101 Manual de usuario Pagina 16