Schneider Electric ALTIVAR 58 TRX Guía de instalación descargar pdf (Pagina 57)

VVDED397047USR6/03 Chapter 2—Menus

06/2003 4—Control Menu

Stop Priorit. PSt

This function gives priority to the

STOP key on the keypad display

no matter what the command

source (terminal strip, keypad

display, or serial link).

No - Yes Yes

To change the PSt parameter to No:

1. Display no.

2. Press ENT.

3. The drive controller displays “See manual”.

4. Press the up arrow key, then the down arrow key, then

ENT, then ESC.

When this parameter is set to No, the stop key on the

keypad display will be inactive. To return to Yes, display

Yes then press enter.

DriveAddress Add

Drive controller address

controlled through the RS-485

port by a MODBUS device (i.e.,

without the programming or

operating keypad display). If this

parameter is set to any numeral

other than 0 prior to the request

to return to Factory Settings, it

will remain set to that numeral

after returning to Factory

Settings.

0 to 31 0

Table 14: 4—Control Menu: Other Parameters

Parameter Code Description

Adjustment

Range

Factory

Setting

★ These parameters are available only with the I/O extension card installed.

WARNING

DISABLED STOP COMMAND

Disabling the stop key on the keypad display will prevent the drive controller from

stopping when the stop key is pressed. An external stop command must be installed

to stop the motor.

Failure to follow this instruction can result in death, serious injury, or equipment

damage.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 125 126

Comentarios a estos manuales

Sin comentarios

Schneider Electric ALTIVAR 58 TRX Guía de instalación Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Schneider Electric ALTIVAR 58 TRX