Schneider Electric ALTIVAR 58 TRX Guía de instalación descargar pdf (Pagina 18)

Chapter 1—Overview VVDED397047USR6/03

Access Levels 06/2003

Access Levels

The position of the access locking switch on the back of the

programming keypad display allows three levels of access to the

menus. Access to the menus can also be prevented by using an

access code (see the 7—File menu on page 90).

Locked Position – Display Mode: use to prevent

modifications to the drive controller programming.

• You can select the dialog language in the Language menu.

• You can display the macro-configuration or the pre-programmed

values for the selected application in the Macro-Configuration

menu.

• You can display the voltage and power rating of your drive

controller in the Identification menu.

• You can display the electrical values, the operational status, or

fault in the 1—Display menu.

Partial Lock Position – Display and Adjustment Modes:

this level is used during startup for access to basic setup parameters.

• You can do everything listed above.

• You can use the 2—Adjust menu to adjust parameters which are

accessible when the motor is running.

Figure 5: Rear View of Keypad Display

Connector (9-pin SUB-D male):

- for direct connection to the drive controller

- for remote mounting, the keypad display can be

connected using a cable provided in kit

VW3A58103

Switch for access locking:

- locked : display mode only, adjustment and

position configuration parameters not

accessible

- partial : display mode and adjustment

lock parameters accessible

position

- total : display mode, adjustment and

unlock configuration parameters accessible

position

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 125 126

Sin comentarios

Schneider Electric ALTIVAR 58 TRX Guía de instalación Pagina 18