Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 9)

975-0540-01-01 Revision B vii

This guide is for use by qualified personnel only.

Important Safety Instructions

This Guide contains important safety instructions that must be followed during

the installation and maintenance of the charge controller. Make sure you read,

understand, and save these safety instructions.

DANGER

HAZARD OF SHOCK, BURN, FIRE, AND EXPLOSION

• The charge controller must be installed and serviced only by qualified

personnel equipped with appropriate personal protective equipment and

following safe electrical work practices.

• The charge controller is energized from multiple sources. Before removing

the covers, consult the system diagram to identify all sources; de-energize,

lock out, and tag out; and wait for two minutes for internal capacitors to

discharge to a safe voltage.

• Before servicing the charge controller, test using a meter rated at least

1000 VDC to make sure all circuits are de-energized.

• The charge controller is provided with integral PV ground fault protection.

Normally grounded conductors could be ungrounded and energized when

a ground fault is indicated. The integral ground fault detection fuse is

located under the wiring compartment cover. Disconnect all sources of

power before opening the cover.

Failure to follow these instructions will result in death or serious injury.

WARNING

LIMITATIONS ON USE

Do not use the charge controller with life support equipment or other medical

equipment or devices.

Failure to follow these instructions can result in death or serious injury.

WARNING

HAZARD OF ELECTRIC SHOCK

For installation indoors only. Do not expose the charge controller to rain, snow,

dust, or liquids of any type.

Failure to follow these instructions can result in death or serious injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 9