Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 21)

Mounting

975-0540-01-01 Revision B 2–3

This guide is for use by qualified personnel only.

Mounting

The instructions in this chapter are applicable to a typical stand-alone

installation. Installation procedures will vary according to your specific

application. For special applications, consult a qualified Renewable Energy

System Installer or a Certified Dealer.

Choosing a Location

WARNING

HAZARD OF ELECTRIC SHOCK AND FIRE

The PV array voltage must never exceed 600 V

, including the local

temperature correction factor required by the local electrical code. The PV

array maximum circuit current must not exceed 35 A, including the multiplier

required by the local electrical code. For example, the multiplier required by

the NEC and the CEC is 125%, so the array STC I

must not exceed 28 A

(28 A x 125% = 35 A).

Failure to follow these instructions can result in death or serious injury.

WARNING

HAZARD OF ELECTRIC SHOCK, BURN, FIRE, AND EXPLOSION

RISK OF EQUIPMENT DAMAGE

The charge controller must be mounted vertically and installed indoors in a

dry, protected location away from flammable materials, sources of high

temperature, moisture, and vibration. The location must also be sheltered from

direct sunlight, dust, and wind-blown debris.

Failure to follow these instructions can result in death or serious injury.

WARNING

HAZARD OF EXPLOSION

Do not install the charge controller in a sealed compartment containing

batteries.

Failure to follow these instructions can result in death or serious injury.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 21