Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 25)

Mounting

975-0540-01-01 Revision B 2–7

This guide is for use by qualified personnel only.

Mounting the Charge Controller

The charge controller must be vertically mounted to the wall using three ¼-inch ×

½-inch (6.35 mm × 12.5 mm) pan head screws. It can also be mounted on the

side of the PDP

(the hardware is provided with the

charge controller

To mount the charge controller (see Figure 2-6 on page 2–8):

1. Remove the wiring compartment cover (see page 2–5).

2. Mark the location of the keyhole slot on the wall.

3. Secure the top mounting screw in the location marked, but leave the screw

head backed out approximately ¼ inch (6 mm).

4. Place the charge controller onto the screw and pull it down into the keyhole

slot.

5. Insert two screws in the two mounting holes provided to secure the charge

controller to the wall.

Figure 2-5 Dimensions and knockout locations

764.0

(30.0)

220.5

(8.68)

44.0

(1.73) KNOCKOUT

28.2

(1.11)/

22.2(0.87)

DUAL KNOCKOUT

35.0 (1.38)/

28.2 (1.11)

DUAL KNOCKOUT 3PL

108.4 (4.27)

61.9 (2.44) 673.4 (26.5)

219.7 (8.65)

Keyhole slot for wall mounting

All measurements in mm (in.)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 25