Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 20)

Installation

2–2 975-0540-01-01 Revision B

This guide is for use by qualified personnel only.

System Control Panel Requirement

An SCP is required for installation, setup, and configuration of the charge

controller. For more information on accessories, see “Accessories” on page A–6.

PV Array Requirements

Each charge controller must be connected to its own PV array. Up to three PV

array strings can be paralleled. See “Connecting Multiple PV Array Strings to

One Unit” on page 2–14.

DANGER

HAZARD OF ELECTRIC SHOCK, BURNS, FIRE, AND EXPLOSION

Installation of this equipment should only be planned and performed by

qualified personnel in accordance with all applicable installation codes. See

“Audience” on page iii for the definition of qualified personnel.

Failure to follow these instructions will result in death or serious injury.

WARNING

HAZARD OF ELECTRIC SHOCK, BURNS, FIRE, AND EXPLOSION

RISK

OF EQUIPMENT DAMAGE

Unsafe conditions and damage to the charge controller could result if the

instructions and electrical, physical, and environmental installation

specifications in this Guide are not obeyed.

Failure to follow these instructions can result in death or serious injury.

NOTICE

The following information only provides general guidelines. PV array

installation is subject to installation codes and, in some areas, inspection and

approval by the authority having jurisdiction. For example, installations in the

United States must be compliant with NEC and, in particular, Article 690.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 20