Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 43)

Commissioning

975-0540-01-01 Revision B 2–25

This guide is for use by qualified personnel only.

If you are commissioning multiple charge controllers, follow these steps to copy

the settings from the configured charge controller to the other charge controllers:

1. On the Select Device menu, select the next charge controller for

configuration.

The Setup menu opens.

2. Press Enter to select Advanced Settings.

The Config menu opens.

3. Scroll to Copy from, and then press Enter to select the charge controller

from which you want to copy. Scroll to select the charge controller with the

device number that matches the first charge controller you configured, and

then press Enter again.

The settings are automatically copied from the selected charge controller.

4. Repeat steps 1 to 3 for the remaining charge controllers.

5. After you have finished configuring, press the Enter, up arrow, and down

arrow buttons simultaneously to hide the Advanced Settings menu item.

Starting the Unit

To start the charge controller or charge controllers:

◆ Close the PV array disconnect switch.

The charge controller or charge controllers start up and wait for a short period to

determine that the input voltage is greater than the minimum PV array start

voltage. After the input voltage exceeds the minimum PV array start voltage, the

charge controllers begin operating.

NOTICE

The Copy from command will not give you any indication that it has

completed its task. To check that the charger settings have been copied

properly, view some of the settings you originally configured.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 43