Schneider Electric Xantrex XW Guía de instalación descargar pdf (Pagina 23)

Mounting

975-0540-01-01 Revision B 2–5

This guide is for use by qualified personnel only.

Removing the Wiring Compartment Cover

Before mounting, remove the wiring compartment cover to access the mounting

holes and the wiring terminals. The wiring compartment cover is secured with

two screws on the front of the charge controller (see Figure 2-2).

The wiring compartment (see Figure 2-3) contains a flexible Lexan™ barrier used

to segregate battery and PV wire routing. In some instances, you must

manipulate this barrier to provide a passage for battery or PV cables running

through the wiring compartment. In this scenario, you must take care to avoid

intermingling of PV and battery wires.

DANGER

HAZARD OF ELECTRIC SHOCK AND ENERGY

Before removing the wiring compartment cover, make sure all sources of

electricity have been disconnected for at least two minutes. Before energizing

the charge controller, make sure the wiring compartment cover has been

replaced with all fasteners.

Failure to follow these instructions will result in death or serious injury.

Figure 2-2 Removing the wiring compartment cover

Remove two screws to

access the wiring terminals.

Figure 2-3 Wiring compartment with Lexan barrier

Lexan barrier

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 61 62

Sin comentarios

Schneider Electric Xantrex XW Guía de instalación Pagina 23