Schneider Electric FX 3NET Manual de servicio Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Installation Instruction 66571764GB3 Fire Detection 35
Schneider Electric Pelco Finland Oy Kalkkipellontie 6, 02650 Espoo, Finland Telephone: +358 10 446 511 Fax: +358 10 446 5103 www.pelco.com/nordic
Document Number 66571764GB3 16 2012
© 2009 Schneider Electric. All rights reserved.
14.2 Free power outputs
The power supply is normally 27 VDC, max. 500 mA. During a
power failure the supply follows the battery voltage. The power
supply may momentarily be 30 VDC at the most.
IOC, SLC and ALCB, PO1 and PO2
ALCA only PO1
MC2, only PO
PO 2
+24V-
PO 1
+24V-
24VDC / 500mA
24VDC / 500mA
PSA , PO1 and PO2; 2 A
PSB , PO1 and PO2; 4 A
PO 2
+24V-
PO 1
+24V-
24VDC / 2A / 4 A
24VDC / 2 A / 4 A
Note!
The max. current consumption of the FX - control
panel (with PSB- power supply board), all loops and
addresses and all control panel outputs is 1 A in
standby condition and 4.5 A in alarm condition. The
standby time required for the system may limit the
max. load of the outputs.
Note!
The max. current consumption of the FXM - control
panel (with PSA- power supply board), all loops and
addresses and all control panel outputs is 0.5 A in
standby condition and 2.2 A in alarm condition. The
standby time required for the system may limit the
max. load of the outputs.
1. Start the control panel.
2. If the control panel gives a fault indication press the “BUZZER SILENCE” button. You may also want
to press the “SILENCE/RESOUND” button to silence fault warning devices.
3. If the control panel gives an earth fault indication, the cause may be an earth leak in the cable or an
earth leak caused by the device to be supplied with power.
4. Power output fault indication means overload or short circuit in the output.
5. Disconnect all power from the control panel, repair any fault and restart the control panel.
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 57 58

Comentarios a estos manuales

Sin comentarios