
PLSED309039EN PM1000 Series Power Meters
08/2010 Chapter 2 – Quick Start Guide
© 2010 Schneider Electric. All rights reserved.
OLD TOT = OLD Total Integrator
DIAG = represents diagnostic pages. The values
contained in these pages are for factory testing only
SET = Has two modes: EDIT/VIEW set parameters
CLR = Clears INTG and MD values
t.VAh = OLD Total Volt-ampere hours
Dia1 = Communication settings
VIEW = To view simultaneous setup parameter
Dia2 = Product model and version number
EDIT = To edit simultaneous setup parameter
Dia3 = Display scanning for display LED check
t.Wh = OLD Total Watt hours
t.VAR = OLD Total Reactive energy, inductive
-t.VAR = OLD Total Reactive energy, capacitive
t.Run = OLD Total Run hours
OLD Rev = OLD Reverse Integrator
R.VAh = OLD Reverse Volt-ampere hours
R.Wh = OLD Reverse Watt hours
R.VAR = OLD Reverse Reactive energy, inductive
-R.VAR = OLD Reverse Reactive energy, capacitive
R.Run = OLD Reverse Run hours
OLD Fwd = OLD Forward Integrator
VAh = OLD Fwd Volt-ampere hours
VARh = OLD Fwd Reactive energy, inductive
-VARh = OLD Fwd Reactive energy, capacitive
Run.h = OLD Fwd Run hours
Comentarios a estos manuales