Schneider Electric K series Manual de usuario descargar pdf (Pagina 21)

PLSED309039EN PM1000 Series Power Meters

08/2010 Chapter 2 – Quick Start Guide

Edit Set Parameters in PROG Menu

This example explains how to edit the value of A.SEC from 5.000 to 1.000 in

PROG menu setup of the power meter.

For easy understanding, setup parameter editing is explained two parts: edit

and accept setup, and to save the new value in the setup.

NOTE: After entering into setup, when there is no key press for > 2 min, the power meter will exit

from the setup automatically.

Edit and Accept Setup

NOTE: means blinking

2 Means blinking 2

1. After you have successfully entered setup menu in edit mode, (Refer to

―Enter setup menu in Edit mode‖ on page 19 for more information) press

. The display shows EDIT A.SEC 5.000.

2. Press . The display shows EDIT A.SEC 5.000 with blinking 5. The

value can be edited.

3. Press four times. The display shows EDIT A.SEC 1.000 with blinking

4. Press to accept the new value.

To edit the next parameter, press and repeat the above steps.

EDIT

A.PRI

100.0

EDIT

A.SEC

5.000

5. 000

1. 000

1.000

SET

RMS

CLR

VIEW

EDIT

CODE

2 000

CODE

1 000

PASS

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 80 81

Sin comentarios

Schneider Electric K series Manual de usuario Pagina 21