Schneider Electric K series Manual de usuario descargar pdf (Pagina 24)

PM1000 Series Power Meters PLSED309039EN

Chapter 2 – Quick Start Guide 08/2010

MD Clear

1. From RMS, press . The display shows CLR.

CODE entry is required to clear the INTG values.

2. Press for two seconds. The display shows CODE 2000 with blinking

2. The factory set CODE is 1000.

3. Press . The display shows CODE 1000 with blinking 1.

4. Press once or four times to accept the new value.

After the successful CODE entry, the display shows CLR INTG.

5. Press . The display shows CLR MD

6. Press . The display shows CLR MD y with blinking y.

7. Press to clear MD. The display flashes PASS and then CLR MD.

8. Press . The display shows CLR.

9. Press to return to RMS page.

NOTE: If you do not want to clear the maximum demand, press to change the value from

CLR MD y to CLR MD n in step 6. Then press . The display flashes FAIL and shows CLR

MD. Proceed to step 8.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 80 81

Sin comentarios

Schneider Electric K series Manual de usuario Pagina 24