Schneider Electric Splitter Boxes Especificaciones descargar pdf (Pagina 22)

AS-i Bus

Inductive Proximity Sensors

03/00

■ Terminal capacity: 2 x 16 AWG. Cable gland not included with sensor. Cable gland XSZPE13 to be ordered separately.

▲ Sr = Real sensing distance: sensing distance measured at rated supply voltage and at rated ambient temperature

(0.9 Sn - Sr - 1.1 Sn).

◆ Indication of detection of an object outside the correct operating zone of the sensor (see LED function table, page 23).

● Diagnostic function. Quick location of the sensor by its flashing yellow LED.

Sensors

Flush Mountable in Metal Non Flush Mountable

Nominal sensing

distance (Sn)

0.39 inches (10 mm) 0.59 inches (15 mm) 0.79 inches (20 mm)

Selection

Catalog Number

XS1M30AS101 XS7C40AS101 XS8C40AS101

Specifications

Product Certifications

AS-i No. 16901 AS-i No. 10001

Ambient Air

Temperature

Operation: -13 °F to +158 °F (-25 °C to +70 °C) Storage: -40 °F to +185 °F (-40 °C to + 85 °C)

Degree of Protection

IP 67

Shock Resistance

50 g, 11 ms conforming to IEC 68-2-27

Vibration Resistance

25 g at 55 Hz, amplitude ± 2 mm, f = 10 to 55 Hz, conforming to IEC 68-2-6

Materials

Nickel plated brass PEI PEI

Connection

Pre-cabled with moulded M12 end

connector.

Cable length: 2.62 ft (0.8 m)

Screw terminals ■ Screw terminals ■

Operating Zone

0.08 to 0.31 in (2 to 8 mm) 0.12 to 0.47 in (3 to 12 mm) 0.16 to 0.63 in (4 to 16 mm)

Repeat Accuracy

3% of Sr (2)

Differential Travel

1 to 15% of Sr ▲ 3 to 20% of Sr ▲ 3 to 20% of Sr ▲

Delays

First-up: ≤5 ms; response: ≤ 2 ms; recovery: ≤ 2 ms

Maximum Switching

Frequency

150 Hz

Indicators

Output: yellow LED

Alarm ◆: red LED

Output: yellow LED

Alarm ◆: red LED

Output: yellow LED

Alarm ◆: red LED

Power Supply

From the AS-i bus

Current Consumption

from Bus

≤35 mA

Compliance

Standards

UL Listed E164353 CCN NKCR

Data Exchange Specifications

AS-i Profile

S1.1

Data Bits (Status)

Bit value 0 1

State D0 (I) Signal “off” Signal “on”

State D1 (I) Alarm “on” (3) Alarm “off”

State D2 (I) Sensor out of service Sensor in service

Data Bits (Commands)

Command D3 (O) Not used

Parameter Bits

Bit value 0 1

Parameter P0 Not used

Parameter P1 Not used

Parameter P2 Not used

Parameter P3 Flash “on” ● Flash “off”

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Comentarios a estos manuales

Sin comentarios

Schneider Electric Splitter Boxes Especificaciones Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Cortadoras De Troncos Schneider Electric Splitter Boxes