Schneider Electric Mupgrade Utility Guía de instalación descargar pdf (Pagina 17)

Introduction and Installation

1–6 975-0720-01-01

This manual is for use by qualified personnel only

Connecting the USB-to-Xanbus Adapter to Your Computer

To connect the USB-to-Xanbus adapter:

1. Connect the built-in USB cable of the USB-to-Xanbus adapter to an available

USB port on your computer.

2. When it is connected, a green LED indicates the presence of the operating

voltage and flashes during the start-up/reset process.

Note: A red LED indicates an error during start-up/reset by flashing three

times.

3. If a “Found New Hardware” message or Wizard appears in the status area of

your desktop, close it.

4. Proceed to “Configuring the USB-to-Xanbus Adapter Driver Software”.

Configuring the USB-to-Xanbus Adapter Driver Software

Before you can operate Conext Configuration Tool, you must configure the USB-

to-Xanbus adapter driver software.

To configure the USB-to-Xanbus adapter driver software:

1. With the USB-to-Xanbus adapter connected to your computer, run Start > All

Programs > ifak system > CAN > isCAN driver config.

2. Click Add.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 129 130

Sin comentarios

Schneider Electric Mupgrade Utility Guía de instalación Pagina 17