Schneider Electric Modbus Plus Network Bridge Multiplexer none Guía de usuario descargar pdf (Pagina 99)

MBX Driver Help

Cyberlogic Technologies Inc. - 99 -

Determining Peer Cop Support

Before determining whether your card supports Peer Cop, be sure the card is installed

and properly configured. Refer to the Quick-Start Guide section for more information.

Note

You may use the following procedure to determine if Peer Cop is supported even if

Peer Cop was not enabled during the board configuration.

Once you verify that your card functions correctly, follow the procedure described below.

1. Start the MBX Demo program.

2. Select the

[1] Set device number

option and enter the device number of your

card.

3. Select the

[C] Device information

option.

4. Locate the

Supports Peer Cop

field. If this field reports Yes, then your card

supports Peer Cop. If No, then your card does not support Peer Cop.

Event Viewer

During startup and operation, the MBX drivers may detect problems or other significant

events. When a noteworthy event is detected, the driver sends an appropriate message

to the Windows Event Logger. You can view these messages using the following

procedure.

1. Open the Windows

Start

menu and locate the product suite you have installed.

From there, go to

Diagnostics

and select

Event Viewer

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 115 116

Sin comentarios

Schneider Electric Modbus Plus Network Bridge Multiplexer none Guía de usuario Pagina 99