Schneider Electric Modbus Plus Network Bridge Multiplexer none Guía de usuario descargar pdf (Pagina 77)

MBX Driver Help

Cyberlogic Technologies Inc. - 77 -

1. Shutdown Windows and turn off your computer.

2. If the adapter card is already installed in the computer, open the case and remove

the card. It will look similar to the diagram above.

3. Locate the IRQ jumper block on the card. Move the IRQ jumper to the desired IRQ

position.

4. Insert the adapter card back into the computer and turn on the computer. Refer to

the Validation & Troubleshooting section to verify the card’s operation.

For more information on adapter card configuration, refer to

Modicon IBM Host Based

Devices User's Guide

from Schneider Electric (Order #890 USE 102 00).

Bus Number

The Windows architecture allows multiple buses of the same type in the same system.

This parameter specifies the bus number for the adapter card. The default for this

parameter is 0, and in most cases should not be changed.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 115 116

Sin comentarios

Schneider Electric Modbus Plus Network Bridge Multiplexer none Guía de usuario Pagina 77