Schneider Electric Mupgrade Utility Manual de usuario descargar pdf (Pagina 7)

Upgrading ION Device Firmware Before Using the Device Upgrader

Ifthetimestampiscurrent—ifthedateiscorrectandthecurrenttimeiswithin

thetimestampinterval—thentheIONLogInserterServiceiscaught up.

Notethatthetimesta mpintervalisthedurationbetweentimestamps.In this

example,thetimestampintervalis15minutes.

Modifying the transmit delay for Ethernet devices

ForEthernet‐enabledION8800,ION8600orION7550/I ON 765 0meters,youcanset

theTransmitDelayparameterto0forfasterfirmwareupgrades.Notethatyou

shouldalsosetthe UseAck/N acksparametertoNowhenyoumodifythetransmit

delayforthesedevices.

UpgradingfirmwareforION7300seriesmetersrequires

aminimumtransmit

delayof50ms;however,itisrecommendedthatthedefault150mstransmitdelay

beused.Checkthissettingbeforeyouattempttoupgradeyourdevice.Failureto

haveaminimumof50mstransmitdelayforION7300seriesdevicesmayresultin

upgradefailure.

Configuring device transmit delay

1. Startthe

ManagementConsole.ClicktheDevicesiconintheleft‐handpane.

2. Right‐clickthedeviceyouwanttoupgradeinthelistofdevicesandselect

Properties.

3. Right‐clickinthedialogboxandselectAdvancedProperties.



4. SetTransmitDelaytoatleast50ms(150msisrecommended)forION7300series

meters,orsetTransmitDelayto0forION7550,ION7650,ION8600andION8800

meters(setUseAck/NackstoNo forthisla ttergroupofdevicestoo.)

5. ClickOK.

This must be set to a minimum

of 50 ms for ION7300 series

meters (150 ms is the default).

1 2 3 4 5 6 7 8 9

Sin comentarios

Schneider Electric Mupgrade Utility Manual de usuario Pagina 7